Post-Installation/Pre-Print
Pages relating to steps to take after initial installation and before printing.
Calibration Process (Start Here)
Configuration Checks Calibrating probe X and Y offsets Define [bed_screws] in printer.cfg Ad...
Configuration Checks
This document provides a list of steps to help confirm the pin settings in the Klipper printer.cf...
Bed Leveling
Bed leveling (sometimes also referred to as "bed tramming") is critical to getting high quality p...
Probe Calibration
This document describes the method for calibrating the X, Y, and Z offsets of an "automatic z pro...
Manual Leveling
This document describes tools for calibrating a Z endstop and for performing adjustments to bed l...
Bed Mesh
Bed Mesh The Bed Mesh module may be used to compensate for bed surface irregularities to achieve...
BL-Touch
Connecting BL-Touch A warning before you start: Avoid touching the BL-Touch pin with your bare f...
Extruder Calibration
Also, see this section for Klipper's direction for extruder calibration. Also known as “e-steps”...
Slicers
This document provides some tips for configuring a "slicer" application for use with Klipper. Com...
Rotation Distance
Stepper motor drivers on Klipper require a rotation_distance parameter in each stepper config sec...
Nozzle Temperature
Each type of plastic, and each colorant for each type of plastic alters the ideal printing temper...
Pressure Advance | Tower Method (Klipper)
This document provides information on tuning the "pressure advance" configuration variable for a ...
Pressure Advance | Pattern Method (Recommended)
This page is compatible with Klipper, Marlin, and RepRapFirmware. You should calibrate you...
Videos
BL Touch complete setup for Klipper! Maximize your probed bed mesh! - YouTube