Search Results

ELEGOO Blue PLA Amazon Link Diameter 1.718 Extrusion Multiplier .93 Nozzle Temp Calibration 185° seems to be a good temp for speeds up to 60mm/s (150% of 40 mm/s) 205° seems to be a good temp for speeds up to 80mm/s (200% of 40 mm/s)...

Performed Extruder Calibration    

Filament Diameter Extrusion Multiplier (Flow Rate) Nozzle Temperature Pressure Advance  Retraction

Unifi 8 Port Switch Rack Mount Nozzle Temp First Layer: 220° Other Layers: 200° Bed Temp First Layer: 65° Other Layers: 50° Brim Brim: 11mm

 This page is compatible with Klipper, Marlin, and RepRapFirmware. You should  calibrate your extruder first.  Marlin: Linear advance must be  enabled in firmware. Not all printers have it enabled by default. Visit my  calibration tool. Fill ...

04/06/2026 - This was done so that I could use the Raspberry Pi 4B that was being used for Mainsail as the host for Pi-hole instead. Mainsail was migrated to a Raspberry Pi 3B+. This guide assumes: Source: Raspberry Pi 4B running MainsailOS 1.3.2 (64‑bit Bul...

Overview Mainsail OS runs on Raspberry Pi OS. Unattended-upgrades handles automatic installation of security updates. This page covers enabling it and verifying it is working. Enable Unattended Upgrades Install packages sudo apt update sudo apt install unatten...

Overview The Ender 3 S1 Pro runs an STM32F401 MCU. Klipper requires the MCU firmware and the host (klippy) to be built from the same source version. When the host is updated (e.g., after reprovisioning the Pi), the MCU firmware will lag behind and Klipper will...