Recently Updated Pages

Overview Mainsail OS runs on Raspberry Pi OS. Unattended-upgrades handles automatic installation ...

Overview The Ender 3 S1 Pro runs an STM32F401 MCU. Klipper requires the MCU firmware and the host...

Main Panel PNL1 CKT 1 - 100A - Basement Subpanel - Double PolePNL1 CKT 2 - 20A - Washing MachineP...

04/06/2026 - This was done so that I could use the Raspberry Pi 4B that was being used for Mainsa...

Filament Diameter Extrusion Multiplier (Flow Rate) Nozzle Temperature Pressure Advance  Ret...

This document provides information on tuning the "pressure advance" configuration variable for a ...

Configuration Checks Calibrating probe X and Y offsets Define [bed_screws] in printer.cfg Ad...

 This page is compatible with Klipper, Marlin, and RepRapFirmware. You should  calibrate you...

ELEGOO Blue PLA Amazon Link Diameter 1.718 Extrusion Multiplier .93 Nozzle Te...

Flow Rate Calibration - Improve Print Accuracy | 3D Print Beginner https://ellis3dp.com/Print-Tu...

Unifi 8 Port Switch Rack Mount Nozzle Temp First Layer: 220° Other Layers: 200° Bed T...

Each type of plastic, and each colorant for each type of plastic alters the ideal printing temper...

Stepper motor drivers on Klipper require a rotation_distance parameter in each stepper config sec...

Performed Extruder Calibration    

Found here: klipper/config/printer-creality-ender3-s1-2021.cfg at master · Klipper3d/klipper # T...

BL Touch complete setup for Klipper! Maximize your probed bed mesh! - YouTube

Installed new nozzle and rubber on 3/25/24 @ 9:30 PM.

##################Creality Ender 3 S1 Pro Klipper Config - 3DPrintBeginner############### ######...

 Flow Rate Calibration Calibration cube Temp bridge (if using new filament)  Retraction test.

Bed Mesh The Bed Mesh module may be used to compensate for bed surface irregularities to achieve...